Czech version
   
TMM 5024 - 3s OPTO PL No. 0230 
7 to 24 cells processor speed controller 50 A for brushless, sensorless motor (gliders, aircraft), OPTO version, with switch
TMM 5024 - 3s OPTO  PL
  TECHNICAL DATA  
Suitable for motors Mega AC, Model Motors, MP JET, PJS, Űberall model, Hacker, Kontronik, LRK, Plettenberg, etc. Controllers feature "soft start" and are suitable even for motors equipped with gearbox.
Version OPTO
Recommended use Aircraft, gliders, for motor with or without gearbox
Number of NiCd / NiMh feeding cells 7 to 24
Max. continuous current 50 A
max. proud po dobu 5 sec. 60 A
Recommended load BLDC motor
Switching freq. of the motor (PWM) 8 kHz
Number of regulation steps 1024
On-state switch resistance at 25 °C 2×0,0013 Ohm
Max. current of BEC 5,0 V circuit (for 25°C) --
JR gold connector, cables 0,15 mm2
Dimensions (incl. input capacitors) 79 × 30 × 12 mm
Weight without cables 40 g
Total weight with all cables 54 g
Power cables of length 90 mm 2,5 mm2
Current fuse of the controller + ACF yes
Automatic current reduce (ACR) yes
Intelligent power reduce for empty battery (IPR) yes
Thermal fuse of the controller yes
Programming parameters permanent memory yes
Automatically programmed parameters parameters of control signal, number and quality of cells, current fuse, cut of voltage
Programmed parameters Min. and max. position of the throttle, Initial setting, Brake on/off, Brake strenght, Acceleration speed, Timing , Behaviour when accu is discharged
   
 Download the manual (PDF - 188 Kb) Manual (PDF 188 Kb) 

Print page Print page



Reklamní banner
© Všechna práva vyhrazena, webdesign by Mirek Horák.